Management Commands
496
ProSAFE M7100 Managed Switches
Network Interface Commands
This section describes the commands you use to configure a logical interface for management
access. To configure the management VLAN, see network mgmt_vlan on page 48.
enable (Privileged EXEC access)
Use this command to access the Privileged EXEC mode. From the Privileged EXEC mode, you can
configure the network interface.
network parms
Use this command to set the IP address, subnet mask, and gateway of the device. The IP address
and the gateway must be on the same subnet.
network protocol
Use this command to specify the network configuration protocol to be used. If you modify this
value, change is effective immediately. If you use the bootp parameter, the switch periodically
sends requests to a BootP server until a response is received. If you use the dhcp parameter, the
switch periodically sends requests to a DHCP server until a response is received. If you use the
none parameter, you must configure the network information for the switch manually.
network mac-address
Use this command to set locally administered MAC addresses. The following rules apply:
• Bit 6 of byt
e 0 (called the U/L bit) indicates whether the address is universally administered
(b'0') or locally administered (b'1').
• Bit 7 of byt
e 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
Format enable
Mode User EXEC
Format network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC
Default none
Format network protocol {none | bootp | dhcp}
Mode Privileged EXEC
To Next Page
Loading...
