Switching Commands
68
ProSAFE M7100 Managed Switches
show garp
This command displays GARP information.
GVRP Commands
This section describes the commands you use to configure and view GARP VLAN Registration
Protocol (GVRP) information. GVRP-enabled switches exchange VLAN configuration information,
which allows GVRP to provide dynamic VLAN creation on trunk ports and automatic VLAN
pruning.
Note: If GVRP is disabled, the system does not forward GVRP messages.
set gvrp adminmode
This command enables GVRP on the system.
no set gvrp adminmode
This command disables GVRP.
Format show garp
Mode • Privileged EXEC
• User EXEC
Term Definition
GMRP Admin Mode The administrative mode of GARP Multicast Registration Protocol (GMRP) for the
sy
stem.
GVRP Admin Mode The administrative mode of GARP VLAN Registration Protocol (GVRP) for the system.
Default disabled
Format set gvrp adminmode
Mode Privileged EXEC
Format no set gvrp adminmode
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General