NETGEAR ProSAFE M7100-24X - Udld Port; Udld Reset; Show Udld

Utility Commands
485
ProSAFE M7100 Managed Switches
udld port
This command selects the UDLD mode operating on this interface. If the keyword “aggressive” is
not entered, the port operates in normal mode.
udld reset
This command resets all interfaces that have been shut down by UDLD.
show udld
This command displays the global settings of UDLD.
If you specify the <slot/port> parame
ter, the command displays the UDLD settings for the
specified slot and port.
If specify the all keyword, the command displays the UDLD settings for all ports.
The following table shows the terms and definitions for the global settings of UDLD.
The following table shows the terms and definitions if you specify the <slot/port> parame
ter
or the all keyword.
Default normal
Format udld port [aggressive]
Mode Interface Config
Format udld reset
Mode Privileged EXEC
Format show udld [<slot/port> | all]
Mode • Privileged EXEC
• User EXEC
Term Definition
Admin Mode The global administrative mode of UDLD.
Message Interval The period in seconds between the transmission of UDLD probe packets.
Timeout Interval The period in seconds before a decision is made that link is unidirectional.
Term Definition
Slot/Port The slot and port for the interface.
Admin Mode The administrative mode of UDLD configured on this interface: either Enabled or Disabled.