NETGEAR ProSAFE M7100-24X - Qos

Log Messages
605
ProSAFE M7100 Managed Switches
QoS
Table 42. ACL Log Messages
Component Message Cause
ACL Total number of ACL rules (x) exceeds max
(y) on intf i.
The c
ombination of all ACLs applied to an
interface has resulted in requiring more rules
than the platform supports.
ACL ACL name, rule x: This rule is not being
logged
The ACL configuration has resulted in a
r
equir
ement for more logging rules than the
platform supports. The specified rule is
functioning normally except for the logging
action.
ACL aclLogTask: error logging ACL rule trap for
c
or
relator number
The system was unable to send an SNMP trap
for this ACL rule which contains a logging
attribute.
ACL IP ACL number: Forced truncation of one or
mor
e rules during c
onfig migration
While processing the saved configuration, the
system encountered an ACL with more rules
than is supported by the current version. This
might happen when code is updated to a
version supporting fewer rules per ACL than
the previous version.
Table 43. CoS Log Message
Component Message Cause
COS cosCnfgrInitPhase3Process: Unable to apply
saved c
onfig -- using factory defaults
The COS component was unable to apply the
saved configuration and has initialized to the
factory default settings.
Table 44. DiffServ Log Messages
Component Message Cause
DiffServ diffserv.c 165: diffServRestore Failed to
rese
t DiffServ. Recommend resetting device
While attempting to clear the running
configuration an error was encountered in
removing the current settings. This might
lead to an inconsistent state in the system
and resetting is advised.
DiffServ Policy invalid for service intf: "policy name,
intIfNum x
, dir
ection y
The DiffServ policy definition is not
compatible with the capabilities of the
interface specified. Check the platform
release notes for information about
configuration limitations.