Security Commands
314
ProSAFE M7100 Managed Switches
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadc
ast storm recovery.
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a percentage
of link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery
is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of unknown unicast traffic will be limited to the configured threshold. This command also
enables unicast storm recovery mode for an interface.
Format no storm-control broadcast rate
Mode Global Config
Default disabled
Format storm-control unicast
Mode Interface Config
Format no storm-control unicast
Mode Interface Config
Default 5
Format storm-control unicast level <0-100>
Mode Interface Config
To Next Page
Loading...
Need help?
General