NETGEAR ProSAFE M7100-24X - Debug Ipv6 Pimsm Packet; Debug Lacp Packet

Utility Commands
456
ProSAFE M7100 Managed Switches
no debug ipv6 pimdm packet
Use this command to disable debug tracing of PIMDMv6 packet reception and transmission.
debug ipv6 pimsm packet
Use this command to trace PIMSMv6 packet reception and transmission. receive traces only
received PIMSMv6 packets and transmit traces only transmitted PIMSMv6 packets. When
neither keyword is used in the command, then all PIMSMv6 packet traces are dumped. Vital
information such as source address, destination address, control packet type, packet length, and
the interface on which the packet is received or transmitted is displayed on the console.
no debug ipv6 pimsm packet
Use this command to disable debug tracing of PIMSMv6 packet reception and transmission.
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
Default disabled
Format debug ipv6 pimdm packet [receive | transmit]
Mode Privileged EXEC
Default disabled
Format debug ipv6 pimsm packet [receive | transmit]
Mode Privileged EXEC
Format no debug ipv6 pimsm packet [receive | transmit]
Mode Privileged EXEC
Default disabled
Format debug lacp packet
Mode Privileged EXEC