Security Commands
306
ProSAFE M7100 Managed Switches
dot1x supplicant max-start
Use this command to configure the number of attempts that the supplicant makes to find the
authenticator before the supplicant assumes that there is no authenticator.
no dot1x supplicant max-start
Use this command to set the max-start value to the default.
dot1x supplicant timeout start-period
Use this command to configure the start period timer interval to wait for the EAP identity request
from the authenticator. Specify the start period in seconds.
no dot1x supplicant timeout start-period
Use this command to set the start-period value to the default.
dot1x supplicant timeout held-period
Use this command to configure the held period timer interval to wait for the next authentication
on previous authentication fail. Specify the held period in seconds.
Default 3
Format dot1x supplicant max-start <1-10>
Mode Interface Config
Format no dot1x supplicant max-start
Mode Interface Config
Default 30 seconds
Format dot1x supplicant timeout start-period <1-65535>
Mode Interface Config
Format no dot1x supplicant timeout start-period
Mode Interface Config
Default 30 seconds
Format dot1x supplicant timeout held-period <1-65535>
Mode Interface Config
To Next Page
Loading...
Need help?
General