Utility Commands
451
ProSAFE M7100 Managed Switches
The following parameters are displayed in the trace message:
no debug igmpsnooping receive
This command disables tracing of received IGMP Snooping packets.
debug ip acl
Use this command to enable debug of IP Protocol packets matching the ACL criteria.
no debug ip acl
Use this command to disable debug of IP Protocol packets matching the ACL criteria.
Parameter Definition
RX A packet received by the device.
Intf The interface that the packet went out on. Format used is slot/port (internal interface
number). Unit is alway
s shown as 1 for interfaces on a non-stacking device.
Src_Mac Source MAC address of the packet.
Dest_Mac Destination multicast MAC address of the packet.
Src_IP The source IP address in the ip header in the packet.
Dest_IP The destination multicast ip address in the packet.
Type The type of IGMP packet. Type can be one of the following:
• Membership_Query – IGMP M
embership Quer
y
• V1_Membership_Report – IGMP Version 1 M
embership Report
• V2_Membership_Report – IGMP Version 2 M
embership Report
• V3_Membership_Report – IGMP Version 3 M
embership Report
• V2_Leave_Group – IGMP Version 2 L
eave Group
Group Multicast group address in the IGMP header.
Format no debug igmpsnooping receive
Mode Privileged EXEC
Default disabled
Format debug ip acl <acl-number>
Mode Privileged EXEC
Format no debug ip acl <acl-number>
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General