Switching Commands
98
ProSAFE M7100 Managed Switches
The following CLI output is an example of the command output.
(Netgear Switch) #show vpc role
Self
----
Keepalive config mode.......................... Enabled
Keepalive operational mode..................... Enabled
Priority....................................... 100
System MAC..................................... 00:10:18:82:18:63
Timeout........................................ 5
VPC State...................................... Primary
VPC Role....................................... Primary
Peer
----
Priority....................................... 100
VPC Role....................................... Secondary
System MAC..................................... 00:10:18:82:1b:ab
show vpc peer-keepalive
This command displays the IP address of the peer MLAG switch, which is the IP address that is
used by the DCPDP, the port that is used for the DCPDP, whether peer detection is enabled, and
if enabled, the detection status.
The following CLI output is an example of the command output.
(Netgear Switch) #show vpc peer-keepalive
Peer IP address.........................10.130.14.55
Source IP address.......................10.130.15.55
UDP port................................60000
Peer detection..........................ENABLED
Peer is detected........................TRUE
show vpc statistics
This command displays counters for the keep-alive or peer link messages that the MLAG switch
transmitted and received. Specify the peer-keepalive keyword to display the keep-alive
messages; Specify the peer-link keyword to display the link messages such as the link control,
link data, link BPDU, and link LACPDU messages.
Format show peer-keepalive
Mode Privileged EXEC
Format show vpc statistics {peer-keepalive | peer-link}
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General