Switching Commands
30
ProSAFE M7100 Managed Switches
Spanning Tree Protocol (STP) Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP). STP
helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree c
onfiguration is retained and can be changed, but is not activated.
spanning-tree auto-edge
This command enables auto-edge on the interface or range of interfaces. When enabled, the
interface becomes an edge port if it does not see BPDUs for edge delay time.
no spanning-tree auto-edge
This command disables auto-edge on the interface or range of interfaces.
Default enabled
Format spanning-tree
Mode Global Config
Format no spanning-tree
Mode Global Config
Default enabled
Format spanning-tree auto-edge
Mode Interface Config
Format no spanning-tree auto-edge
Mode Interface Config
To Next Page
Loading...
Need help?
General