Security Commands
296
ProSAFE M7100 Managed Switches
The following tokens are supported:
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port t
o the default values. Depending on the token used, the corresponding default values
are set.
Default • guest-vlan-period: 90 seconds
• reauth-period: 3600 seconds
• quiet-period: 60 seconds
• tx-period: 30 seconds
• supp-timeout: 30 sec
onds
• server-timeout: 30 seconds
F
ormat dot1x timeout {{guest-vlan-period <seconds>} |{reauth-period
<seconds>} | {quiet-period <seconds>} | {tx-period <seconds>} |
{supp-timeout <seconds>} | {server-timeout <seconds>}}
Mode Interface Config
Tokens Definition
guest-vlan-period The time, in seconds, for which the authenticator waits to see if any EAPOL packets are
rec
eived on a port before authorizing the port and placing the port in the guest vlan (if
configured). The guest vlan timer is only relevant when guest vlan has been configured on
that specific port.
reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port to
de
t
ermine when re-authentication of the supplicant takes place. The reauth-period must be
a value in the range 1 - 65535.
quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port to
define periods of time in which it will no
t att
empt to acquire a supplicant. The quiet-period
must be a value in the range 0 - 65535.
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to
de
t
ermine when to send an EAPOL EAP Request/Identity frame to the supplicant. The
quiet-period must be a value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to
timeout the supplic
ant
. The supp-timeout must be a value in the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to
timeout the authentication ser
ver. The supp-timeout must be a value in the range 1 -
65535.
Format no dot1x timeout {guest-vlan-period | reauth-period | quiet-period |
tx-period | supp-timeout | server-timeout}
Mode Interface Config
To Next Page
Loading...
