NETGEAR ProSAFE M7100-24X - Chapter 4 Routing Commands; Address Resolution Protocol (ARP) Commands

Routing Commands
217
ProSAFE M7100 Managed Switches
no ip redirects
Use this command to prevent the generation of ICMP Redirect messages by the router.
ip icmp echo-reply
Use this command to enable the generation of ICMP Echo Reply messages by the router. By
default, the generation of ICMP Echo Reply messages is enabled.
no ip icmp echo-reply
Use this command to prevent the generation of ICMP Echo Reply messages by the router.
ip icmp error-interval
Use this command to limit the rate at which IPv4 ICMP error messages are sent. The rate limit is
configured as a token bucket, with two configurable parameters, burst-size and burst-interval.
The burst-interval specifies how often the token bucket is initialized with burst-size tokens.
burst-interval is from 0 to 2147483647 milliseconds (msec).
The burst-size is the number of ICMP error messages that can be sent during one burst-interval.
The range is from 1 to 200 messages.
To disable ICMP rate limiting, set burst-interval to zero (0).
Format no ip redirects
Mode • Global Config
• Interface Config
Def
ault enabled
Format ip icmp echo-reply
Mode Global Config
Format no ip icmp echo-reply
Mode Global Config
Default • burst-interval of 1000 msec.
• burst-size of 100 messages
F
ormat ip icmp error-interval <burst-interval> [<burst-size>]
Mode Global Config