NETGEAR ProSAFE M7100-24X - Port Lacpmode; Port Lacpmode Enable All

Switching Commands
84
ProSAFE M7100 Managed Switches
static mode for a new port-channel enabled, which means the port-channel is static. You can only
use this command on port-channel interfaces.
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Default disabled
Format port-channel static
Mode Interface Config
Format no port-channel static
Mode Interface Config
Default enabled
Format port lacpmode
Mode Interface Config
Format no port lacpmode
Mode Interface Config
Format port lacpmode enable all
Mode Global Config
Format no port lacpmode enable all
Mode Global Config