Switching Commands
54
ProSAFE M7100 Managed Switches
vlan protocol group
This command adds protocol-based VLAN groups to the system. When it is created, the protocol
group will be assigned a unique number (1-128) that will be used to identify the group in
subsequent commands.
no vlan protocol group
This command removes a protocol group.
vlan protocol group name
This command assigns a name to a protocol-based VLAN group. The groupname variable can be a
character string of 0–16 characters.
no vlan protocol group name
This command removes the name from a protocol-based VLAN group.
vlan protocol group add protocol
This command adds the protocol to the protocol-based VLAN identified by groupid. A group may
have more than one protocol associated with it. Each interface and protocol combination can only
be associated with one group. If adding a protocol to a group causes any conflicts with interfaces
currently associated with the group, this command fails and the protocol is not added to the
group. The possible values for protocol-list include the keywords ip, arp, and ipx and hexadecimal
or decimal values ranging from 0x0600 (1536) to 0xFFFF (65535). The protocol list can accept
up to 16 protocols separated by a comma.
Format vlan protocol group <1-128>
Mode Global Config
Format no vlan protocol group <1-128>
Mode Global Config
Format vlan protocol group name <1-128> <groupname>
Mode Global Config
Format no vlan protocol group name <1-128>
Mode Global Config
Default none
Format vlan protocol group add protocol <groupid> ethertype
{<protocol-list> | arp | ip | ipx}
Mode Global Config
To Next Page
Loading...
Need help?
General