NETGEAR ProSAFE M7100-24X Reference Manual

Switching Commands
97
ProSAFE M7100 Managed Switches
VPC Interface State............................ Active
Local MemberPorts Status
----------------- ------
0/19 UP
0/20 UP
0/21 UP
0/22 UP
Peer MemberPorts Status
---------------- ------
0/27 UP
0/28 UP
0/29 UP
0/30 UP
show vpc
This command displays information about an MLAG, which you specify by its ID. The command
displays the configuration and operational modes, the port channel that is configured as the
MLAG, and the member ports with their link status on the switch and the peer switch.
The following CLI output is an example of the command output.
(Netgear Switch) #show vpc 10
VPC id#10
-----------------
Config mode..............................Enabled
Operational mode.........................Enabled
Port channel.............................lag 1
Self member ports Status
------------------------ ---------
0/2 UP
0/6 DOWN
Peer member ports Status
------------------------ ---------
0/8 UP
show vpc role
This command displays information about the keep-alive status and parameters, the role of the
MLAG switch, the system MAC address, and the system priority.
Format show vpc <id>
Mode Privileged EXEC
Format show vpc role
Mode Privileged EXEC

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English