NETGEAR ProSAFE M7100-24X - Ip Domain List; Ip Name Server; Ip Name Source-Interface

Utility Commands
436
ProSAFE M7100 Managed Switches
ip domain list
Use this command to define a list of default domain names to complete unqualified names. By
default, the list is empty. Each name must be no more than 256 characters, and should not
include an initial period. The default domain name, configured using the ip domain name
command, is used only when the default domain name list is empty. A maximum of 32 names can
be entered in to this list.
no ip domain list
Use this command to delete a name from a list.
ip name server
Use this command to configure the available name servers. Up to eight servers can be defined in
one command or by using multiple commands. The parameter <server-address> is a valid
IPv4 or IPv6 address of the server. The preference of the servers is determined by the order they
were entered.
no ip name server
Use this command to remove a name server.
ip name source-interface
Use this command to specify the physical or logical interface that must be used as the DNS client
source interface (that is, source IP address) for the DNS client management application. The
address of the source interface is used for all DNS communications between the DNS server and
the DNS client. The IP address of the source interface is used in the IP header of management
protocol packets. Using the IP address in the IP header enables security devices such as firewalls
to identify the source packets from a switch. If you do not use this command to specify a source
Default none
Format ip domain list <name>
Mode Global Config
Format no ip domain list <name>
Mode Global Config
Format ip name-server <server-address1> [<server-address2> ...
<server-address8>]
Mode Global Config
Format no ip name-server <server-address1> [<server-address2> ...
<server-address8>]
Mode Global Config