Switching Commands
83
ProSAFE M7100 Managed Switches
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner’s System ID. The valid range for <priority> is 0–65535.
Note: This command is applicable only to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Par
tner’s System ID.
port-channel local-preference
This command enables the local-preference mode on a port-channel (LAG) interface or range of
interfaces. By default, the local-preference mode for a port-channel is disabled. This command
can be used only on port-channel interfaces.
no port-channel local-preference
This command disables the local-preference mode on a port-channel.
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However if
the maximum number of allowable dynamic port-channels are already present in the system, the
Default 0x0
Format lacp partner system priority <priority>
Mode Interface Config
Format no lacp partner system priority
Mode Interface Config
Default disabled
Format port-channel local-preference
Mode Interface Config
Format no port-channel local-preference
Mode Interface Config
To Next Page
Loading...
Need help?
General