NETGEAR ProSAFE M7100-24X - Page 207

Routing Commands
207
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch)#show ip vrrp interface 0/1 1
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State DecrementPriority
--------------- ------ ------------------
<0/1> down 10
TrackRoute (pfx/len) State DecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
show ip vrrp interface
This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Priority The priority value for the specific virtual router, taking into account any priority decrements
for tracked interfaces or routes.
Configured
Priorit
y
The priority configured through the ip vrrp <vrid> priority <1-254> command.
Advertisement
inter
val
The advertisement interval in seconds for the specific virtual router.
Pre-Empt Mode The preemption mode configured on the specified virtual router.
Administrative
Mode
The status (Enable or Disable) of the specific router.
State The state (Master/backup) of the virtual router.
Format show ip vrrp interface brief
Modes • P
rivileged EXEC
• User EXEC
Term Definition