NETGEAR ProSAFE M7100-24X - Page 154

Switching Commands
154
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch) #show lldp med remote-device detail 0/8
LLDP MED Remote Device Detail
Local Interface: 0/8
Remote Identifier: 18
Capabilities
MED Capabilities Supported: capabilities, networkpolicy, location, extendedpse
MED Capabilities Enabled: capabilities, networkpolicy
Device Class: Endpoint Class I
Network Policies
Media Policy Application Type : voice
Vlan ID: 10
Priority: 5
DSCP: 1
Unknown: False
Tagged: True
Media Policy Application Type : streamingvideo
Vlan ID: 20
Priority: 1
DSCP: 2
Unknown: False
Tagged: True
Inventory
Hardware Rev: xxx xxx xxx
Firmware Rev: xxx xxx xxx
Software Rev: xxx xxx xxx
Serial Num: xxx xxx xxx
Mfg Name: xxx xxx xxx
Device Type Shows the remote device’s PoE device type connected to this port.
Available Shows the remote port’s PSE power value in tenths of a watt.
Source Shows the remote port’s PSE power source.
Priority Shows the remote port’s PSE priority.
Required Shows the remote port’s PD power requirement.
Source Shows the remote port’s PD power source.
Priority
Shows the remote port’s PD power priority.
Term Definition