NETGEAR ProSAFE M7100-24X - Page 260

Quality of Service (QoS) Commands
260
ProSAFE M7100 Managed Switches
Format {deny | permit} {every | {{<protolkey> | <0-255>} {<srcip> <srcmask>
| any | host <srcip>} [{range {<portkey> | <startport>} {<portkey> |
<endport>}} | {eq | neq | lt | gt} {<portkey> | <0-65535>}] {<dstip>
<dstmask> | any | host <dstip>} [{range {<portkey> | <startport>}
{<portkey> | <endport>}} | {eq | neq | lt | gt} {<portkey> |
<0-65535>}] [flag [+fin | -fin] [+syn | -syn] [+rst | -rst] [+psh |
-psh] [+ack | -ack] [+urg | -urg] [established]] [icmp-type
<icmp-type> [icmp-code <icmp-code>] | icmp-message <icmp-message>]
[fragments] [precedence <precedence> | tos <tos> [<tosmask>] | dscp
<dscp>]}} [time-range <time-range-name>] [log] [assign-queue
<queue-id>] [{mirror | redirect} <unit/slot/port>] [rate-limit <rate>
<burst-size>]
Mode Ipv4-Access-List Config
Parameter Description
deny or permit Specifies the action of the IP ACL rule:
• deny
. The IP ACL rule denies the action.
• permit. The IP ACL rule permits the action.
ev
ery The IP ACL matches every packet
protocolkey or number Specifies either the supported protocol key or the protocol number of
the pro
tocol to filter for an extended IP ACL rule:
• pr
otocolkey. The supported protocol key that you can enter is eigrp,
gr
e, icmp, igmp, ip, ipinip, ospf, pim, tcp, or udp.
• number
. Enter a number from 0 to 255.
sr
cip srcmask, any, or host srcip Specifies a source IP address and source netmask for the match
condition of the IP A
CL rule.
• sr
cip and srcmask. Enter the source IP address (scrip) and source
ne
tmask (srcmask).
• any
. The source IP address is 0.0.0.0 and the source network mask
is 255.255.255.255.
• hos
t and srcip. Specify that you use a hostname (host) and enter the
name (scrip). The sour
ce network mask is 0.0.0.0.