Log Messages
610
ProSAFE M7100 Managed Switches
Table 55. IGMP-Proxy Log Messages
Component Message Cause
IGMP-Proxy Error getting memory for igmp host group
rec
ord
When we are unable to allocate memory for
the IGMP group record in the Host (Proxy)
table
IGMP-Proxy Error getting memory for source record When we are unable to allocate memory for
the IGMP sour
c
e record in the Host (Proxy)
table
Table 56. PIM-SM Log Messages
Component Message Cause
PIM-SM PIM-SM not initialized This message arises when trying to activate
pimsm inter
faces or receiving pimsm packets
when pimsm component is not initialized.
PIM-SM Unable to take xxx semaphore This message is logged when failed to acquire
semaphor
e t
o access source list or group list
or candidate Rp list or virtual interface list.
The xxx specifies the list for which the access
is denied.
PIM-SM Warning : Could not send packet type xxx
(pimsm pack
e
t type) on rtrIfNum
this warning is logged when failed to send a
pimsm control packet on the specified router
interface.
PIM-SM add_kernel_cache : memory allocation failed This message is logged when there is
insuf
ficient memor
y to add a mroute entry
into cache.
PIM_SM Config error. Trying to add static RP.
Dynamic RP with same ip addr e
xis
ts
Router learns RP-group mapping through
Bootstrap messages received.This message
pops when the static RP is configured which
conflicts the mapping learnt dynamically
through Bootstrap messages.
PIM-SM Inner xxx(source/group) address of register
mes
sage is inv
alid
This log message appears when a register
message is received with invalid inner ip
source or group address.
Table 57. PIM-DM Log Messages
Component Message Cause
PIM-DM Out of memory when creating xxx This message is logged when there is
insufficient memor
y to accommodate a new
neighbor/(S,G) Entry, Prune, Graft, Join etc.
PIM-DM Error entry->ll_xxx LL creation error This message is logged when the SLL creation
is F
ailed.
To Next Page
Loading...
