Use the Command-Line Interface
13
ProSAFE M7100 Managed Switches
Note: The command modes available on your switch depend on the software
modules that are installed. For example, a switch that does not support
BGPv4 does not have the Router BGPv4 Command Mode.
Table 5. CLI Command Modes
Command Mode Prompt Mode Description
User EXEC Switch> Contains a limited set of commands to view
basic sy
stem information.
Privileged EXEC Switch# Allows you to issue any EXEC command, enter
the VLAN mode, or ent
er the Global
Configuration mode.
Global Config Switch (Config)# Groups general setup commands and permits
you t
o mak
e modifications to the running
configuration.
VLAN Config Switch (Vlan)# Groups all the VLAN commands.
Interface Config Switch (Interface <slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Manages the operation of an interface and
pr
ovides ac
cess to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logic
al c
onnection operation.
Line Config Switch (line)# Contains commands to configure outbound
telne
t settings and console interface settings.
Policy Map Config Switch (Config-policy-map)# Contains the QoS Policy-Map configuration
commands.
P
olicy Class Config Switch (Config-policy-class-map)# Consists of class creation, deletion, and
matching c
ommands. The class match
commands specify Layer 2, Layer 3, and
general match criteria.
Class-Map Config Switch (Config-class-map)# Contains the QoS class map configuration
c
ommands f
or IPv4.
Ipv6_Class-Map
Config
Switch (Config-class-map)# C
ontains the QoS class map configuration
commands for IPv6.
MAC Access-list
Config
Switch (Config-mac-access-list)# Allows you t
o create a MAC Access-List and to
enter the mode containing MAC Access-List
configuration commands.
TACACS Config Switch (Tacacs)# Contains commands to configure properties
f
or the T
ACACS servers.
DHCP Pool Config Switch (Config dhcp-pool)# Contains the DHCP server IP address pool
configur
ation commands.
Stack Global Config
Mode
Switch (Config stack)# Allows you to access the Stack Global Config
Mode.
To Next Page
Loading...
