2
ProSAFE M7100 Managed Switches
Support
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your product and use it to register your product at
https://my.netgear.com. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends
registering your product through the NETGEAR website. For product updates and web support, visit http://support.netgear.com.
Phone (US & Canada only): 1-888-NETGEAR.
Phone (Other Countries): Check the list of phone numbers at http://support.netgear.com/general/contact/default.aspx.
Compliance
For regulatory compliance information, visit http://www.netgear.com/about/regulatory.
Trademarks
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of NETGEAR, Inc. and/or
its subsidiaries in the United States and/or other countries. Information is subject to change without notice. © NETGEAR, Inc. All
rights reserved.
Revision History
Publication Part
Number
Version Publish Date Comments
202-11332-01 Not applicable October 2013 Updated the manual to a new format.
Added the following new command sections:
• Special Command-Mode Independent Commands
• Private Group Commands
• Alternative Store and Forward Commands
• Multichassis LAG Commands
• Port Mirroring Commands
• DHCPv6 Snooping Configuration Commands
• MBUF Utilization Commands
• Full Memory Dump Commands
Removed the following command sections:
• Open Shor
t
est Path First (OSPF) Commands
• OSPF Grac
eful Restart Commands
• Routing Information Protocol (RIP) Commands
• Tunnel Interface Commands
• IPv6 Routing Commands
• OSPFv3 Commands
• OSPFv3 Grac
eful Restart Commands
• DHCPv6 Commands
• Multicast Commands
• DVMRP Commands
• PIM Commands
• Internet Group Message Protocol (IGMP) Commands
• IGMP Proxy Commands
• IPv6 Multicast Forwarder Commands
• IPv6 PIM Commands
• IPv6 MLD Commands
To Next Page
Loading...
