Quality of Service (QoS) Commands
238
ProSAFE M7100 Managed Switches
mirror
This command specifies that all incoming packets for the associated traffic stream are copied to a
specific egress interface (physical port or LAG).
redirect
This command specifies that all incoming packets for the associated traffic stream are redirected
to a specific egress interface (physical port or port-channel).
conform-color
Use this command to enable color-aware traffic policing and define the conform-color class map.
Used with the police command where the fields for the conform level are specified. The
<class-map-name> parameter is the name of an existing DiffServ class map.
Note: This command might only be used after specifying a police command for
the policy-class instance.
class
This command creates an instance of a class definition within the specified policy for defining
treatment of the traffic class through subsequent policy attribute statements. The
<classname> is the name of an existing DiffServ class.
Note: This command causes the specified policy to create a reference to the
class definition.
Format mirror <slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Redirect
Format redirect <slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Mirror
Format conform-color <class-map-name>
Mode Policy-Class-Map Config
To Next Page
Loading...
