NETGEAR ProSAFE M7100-24X - Page 241

Quality of Service (QoS) Commands
241
ProSAFE M7100 Managed Switches
police-single-rate
This command is the single-rate form of the police command and is used to establish the traffic
policing style for the specified class. For each outcome, the only possible actions are represented
by the following keywords:
• drop
• set-cos-as-sec-cost
• set-cos-transmit
• set-sec-cos-transmit
• set-dscp-transmit
• set-prec-transmit
• transmit
In this single-rate form of the police command, the default conform action is to send the traffic,
the def
ault e
xceed action is to drop the traffic, and the default violate action is also to drop the
traffic.
Use this command to set the committed information rate (CIR; from 1 to 4,294,967,295),
committ
ed burst size (CBS; from 1 to 128), excess burst size (EBS; from 1 to 128), and the
police actions.
Format police-simple {<1-4294967295> <1-128> conform-action {drop |
set-prec-transmit <0-7> | set-dscp-transmit <0-63> |
set-cos-transmit <0-7> | transmit} [violate-action {drop |
set-prec-transmit <0-7> | set-dscp-transmit <0-63> |
set-cos-transmit <0-7> | transmit}]}
Mode Policy-Class-Map Config
Incompatibilities Drop, Mark (all forms)
Format police-single-rate {<1-4294967295> <1-128> <1-128>
conform-action {drop | set-cos-as-sec-cos | set-cos-transmit
<0-7> | set-sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit} exceed-action {drop |
set-cos-as-sec-cos | set-cos-transmit <0-7> |
set-sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit} [violate-action {drop |
set-cos-as-sec-cos-transmit | set-cos-transmit <0-7> |
set-sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit}]}
Mode Policy-Class-Map Config