NETGEAR ProSAFE M7100-24X - Page 256

Quality of Service (QoS) Commands
256
ProSAFE M7100 Managed Switches
srcip srcmask, any, or host srcip Specifies a source IP address and source netmask for the match
condition of the IP ACL rule.
• sr
cip and srcmask. Enter the source IP address (scrip) and source
ne
tmask (srcmask).
• any
. The source IP address is 0.0.0.0 and the source network mask
is 255.255.255.255.
• hos
t and srcip. Specify that you use a hostname (host) and enter the
name (scrip). The sour
ce network mask is 0.0.0.0.
range
portkey or startport
and
portkey or endport
or
eq, neq, lt, or gt
and
portkey or 0-65535
Note: This option is available only if the protocolkey is either tcp or
udp.
Specifies the layer 4 port match condition for the IP ACL rule if the
layer 4 por
t number f
alls within the specified port range. Enter a start
port number (startport) or portkey and enter an end port number
(endport) or portkey:
• portkey. The available portkeys depend on the protocol:
- T
CP. Enter bgp, domain, echo, ftp, ftp-data, http, smtp, telnet,
www, pop2, or pop3.
- UDP
. Enter domain, echo, ntp, rip, snmp, tftp, time, or who.
Each of these keywords translates into its equivalent port number.
• s
tartport. A port number from 0 to 65535.
• endport. A port number from 0 to 65535. The end port must have
a value equal or greater than the start port.
Alternately, you can specify a single keyword and a portkey or port
number
. With this me
thod, two rules are added: one rule with a range
from 0 to the specified port number (or portkey) minus 1 and one rule
with a range from the specified port number plus 1 to 65535.
• eg. The IP ACL rule mat
ches only if the layer 4 port number is equal
to the specified port number or portkey.
• lt
. The IP ACL rule matches if the layer 4 port number is lower than
the specified por
t number or portkey.
• gt
. The IP ACL rule matches if the layer 4 port number is higher than
the specified por
t number or portkey.
• neq. The IP A
CL rule mat
ches only if the layer 4 port number is not
equal to the specified port number or portkey.
• por
tkey. The available portkeys depend on the protocol:
- T
CP. Enter bgp, domain, echo, ftp, ftp-data, http, smtp, telnet,
www, pop2, or pop3.
- UDP
. Enter domain, echo, ntp, rip, snmp, tftp, time, or who.
• 0-65535. A por
t number fr
om 0 to 65535.
dstip dstmask, any, or host dstip Specifies a destination IP address and source netmask for the match
condition of the IP A
CL rule.
• ds
tip and dstmask. Enter the destination IP address (dstip) and
des
tination netmask (dstmask).
• any
. The destination IP address is 0.0.0.0 and the destination
ne
twork mask is 255.255.255.255.
• host and dstip. Specify that you use a hostname (host) and enter
the name (dstip). The destination network mask is 0.0.0.0.
Parameter Description