NETGEAR ProSAFE M7100-24X - Page 361

Security Commands
361
ProSAFE M7100 Managed Switches
Note: Not all messages below are available in all 7000series managed
switches.
Term Definition
First Fragment
Mode
Might be enabled or disabled. The factory default is disabled.
Min TCP Hdr Size
<0-255>
The factory default is 20.
ICMP Mode Might be enabled or disabled. The factory default is disabled.
Max ICMPv4 Pkt
Siz
e
The r
ange is 0-1023. The factory default is 512.
Max ICMPv6 Pkt
Size
The r
ange is 0-16384. The factory default is 512.
ICMP Fragment
Mode
Might be enabled or disabled. The factory default is disabled.
L4 Port Mode Might be enabled or disabled. The factory default is disabled.
TCP Port Mode Might be enabled or disabled. The factory default is disabled.
UDP Port Mode Might be enabled or disabled. The factory default is disabled.
SIPDIP Mode Might be enabled or disabled. The factory default is disabled.
SMACDMAC
Mode
Might be enabled or disabled. The factory default is disabled.
TCP Flag Mode Might be enabled or disabled. The factory default is disabled.
TCP FIN&URG&
PSH Mode
Might be enabled or disabled. The factory default is disabled.
TCP Flag &
Sequenc
e Mode
Might be enabled or disabled. The f
actory default is disabled.
TCP SYN Mode Might be enabled or disabled. The factory default is disabled.
TCP SYN & FIN
Mode
Might be enabled or disabled. The factory default is disabled.
TCP Fragment
Mode
Might be enabled or disabled. The factory default is disabled.
TCP Offset Mode Might be enabled or disabled. The factory default is disabled.