NETGEAR ProSAFE M7100-24X - IPv6 MLD Commands

Utility Commands
427
ProSAFE M7100 Managed Switches
no domain-name
This command removes the domain name.
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers that
are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command line.
Servers are listed in order of preference (address1 is the most preferred server, address2 is the
next most preferred server, and so on).
no netbios-name-server
This command removes the NetBIOS name server list.
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients. type specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-t
o-peer
• m-node—Mixed
• h-node—Hybrid (rec
ommended)
Format no domain-name
Mode DHCP Pool Config
Default none
Format netbios-name-server <address> [<address2> ... <address8>]
Mode DHCP Pool Config
Format no netbios-name-server
Mode DHCP Pool Config
Default none
Format netbios-node-type <type>
Mode DHCP Pool Config