Utility Commands
458
ProSAFE M7100 Managed Switches
<15> JAN 02 11:03:36 10.50.50.1-2 OSPF[46300472]: ospf_debug.c(293) 25435 % Pkt TX -
Intf:2/0/48 Src
Ip:10.50.50.1 DestIp:192.168.50.2 AreaId:0.0.0.0 Type:LS_UPD Length: 1500
<15> JAN 02 11:03:37 10.50.50.1-2 OSPF[46300472]: ospf_debug.c(293) 25441 % Pkt TX -
Intf:2/0/48 Src
Ip:10.50.50.1 DestIp:224.0.0.6 AreaId:0.0.0.0 Type:LS_ACK Length: 1500
The following parameters are displayed in the trace message:
The remaining fields in the trace are specific to the type of OSPF Packet.
HELLO packet field definitions:
DB_DSCR packet field definitions:
Parameter Definition
TX/RX TX refers to a packet transmitted by the device. RX refers to packets received by the device.
Intf The interface that the packet came in or went out on. Format used is slot/port (internal
inter
face number).
SrcIp The source IP address in the IP header of the packet.
DestIp The destination IP address in the IP header of the packet.
AreaId The area ID in the OSPF header of the packet.
Type Could be one of the following:
HELLO – Hello pack
e
t
DB_DSCR – Database descript
or
LS_REQ – LS Reques
t
LS_UPD – LS Update
LS_ACK
– LS Acknowledge
Parameter Definition
Netmask The netmask in the hello packet.
DesignRouter Designated Router IP address.
Backup Backup router IP address.
Field Definition
MTU MTU
Options Options in the OSPF packet.
To Next Page
Loading...
