NETGEAR ProSAFE M7100-24X - Page 489

Utility Commands
489
ProSAFE M7100 Managed Switches
Show mbuf
This command displays the MBUF utilization monitoring parameters. You can include the total
keyword to display the MBUF statistics.
The following CLI output is an example of the command output.
(Netgear Switch) #show mbuf
MBUF Utilization Monitoring Parameters
Rising Threshold............................... 0 %
Falling Threshold.............................. 0 %
Severity....................................... 5
(Netgear Switch) #show mbuf total
Mbufs Total.................................... 246
Mbufs Free..................................... 246
Mbufs Rx Used.................................. 0
Total Rx Norm Alloc Attempts................... 1095
Total Rx Mid2 Alloc Attempts................... 15949
Total Rx Mid1 Alloc Attempts................... 29637
Total Rx Mid0 Alloc Attempts................... 0
Total Rx High Alloc Attempts................... 15774
Total Tx Alloc Attempts........................ 301526
Total Rx Norm Alloc Failures................... 0
Total Rx Mid2 Alloc Failures................... 0
Total Rx Mid1 Alloc Failures................... 0
Total Rx Mid0 Alloc Failures................... 0
Total Rx High Alloc Failures................... 0
Total Tx Alloc Failures........................
Format show mbuf [total]
Mode Privileged EXEC
Parameter Description
rising-threshold The percentage of the memory buffer resources that, when exceeded for the configured
rising inter
val, triggers a notification. The range is 1 to 100. The default is 0 (disabled).
falling-threshold The percentage of the memory buffer resources that, when usage falls below this level for
the configur
ed interval, triggers a notification. The range is 1 to 100. The default is 0
(disabled).
severity The severity level at which messages are logged.