NETGEAR ProSAFE M7100-24X - Page 563

Management Commands
563
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch) #show radius accounting statistics 192.168.37.200
RADIUS Accounting Server Name................. Default_RADIUS_Server
Host Address.................................. 192.168.37.200
Round Trip Time............................... 0.00
Requests...................................... 0
Retransmissions............................... 0
Responses..................................... 0
Malformed Responses........................... 0
Bad Authenticators............................ 0
Pending Requests.............................. 0
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
(Switch) #show radius accounting statistics name Default_RADIUS_Server
RADIUS Accounting Server Name................. Default_RADIUS_Server
Host Address.................................. 192.168.37.200
Round Trip Time............................... 0.00
Requests...................................... 0
Retransmissions............................... 0
Responses..................................... 0
Malformed Responses........................... 0
Bad Authenticators............................ 0
Pending Requests.............................. 0
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
show radius source-interface
Use this command to display information about the RADIUS client source interface.
The following CLI output is an example of the command output.
(Switch)# show radius source-interface
RADIUS Client Source Interface.............. (not configured)
Format show radius source-interface
Mode Privileged EXEC