Xerox Phaser 7100

Maintenance
Phaser 7100 Service Manual Xerox Internal Use Only6-20
Adjusting the Fuser
Adjust Fuser adjustment is used for optimum print quality across a wide range of paper types.
• If the toner on a print is smearing or can be rubbed off the paper, increase the offset for the
paper.
• If the toner is blistered or mottled, decrease the offset for the paper.
Procedure
1. On the Control Panel, press Menu.
2. Press Down Arrow and navigate to Admin Menu, and press OK.
3. Press Down Arrow and navigate to Image Quality, and press OK.
4. Press Down Arrow and navigate to Fuser Temperature, and press OK.
5. Use Up/ Down Arrow and navigate to the paper type for the adjustment, then press OK.
–Plain
–Bond
–Recycled
–Heavy Weight
–Cardstock
– Glossy
– Glossy Card
–HW Glossy Card
–Envelope
–Postcard
–Labels
6. Press OK to select the paper type.
7. Use Up/ Down Arrow to select the value (1 - 5) and press OK to apply the setting.
8. Repeat the procedure for each paper type that needs adjustment.
9. Press Menu to return to the Ready to Print screen.