Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-146
FIFO Empty
Image expansion error has occurred. (FIFO Empty error).
Applicable Fault Code
• 016-761: <Image Output> FIFO EMPTY Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Print LANG Not Installed
The print language is not installed. The system has requested for a feature (print language, print utility,
etc.) that is not installed. (The decomposer specified in PJL or Auto SW is not installed.)
Applicable Fault Code
• 016-762: <Decomposer Not Exist> The system has requested for a feature (print language, print
utility, etc.) that is not installed.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Print in the High Speed mode. If the problem persists, print in the Print Guarantee mode.
Troubleshooting Procedure
Step Actions and Questions
1. Fix and select the decomposer from the Control Panel or with a command.