Xerox Phaser 7100 Service Manual

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-125
HD Full by Annotation/ Watermark Image
When an Annotation/ Watermark image was to be stored in the HDD, Full status was detected and the
job was aborted.
Applicable Fault Code
• 016-708: Full During Annotation/ Analog Watermark Image Storage
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Cancel Annotation/ Watermark and repeat the operation.
2. Reduce the number of document pages. In Mixed Size mode, only a single size is available.
3. For printing Stored Document, delete unnecessary documents from the HDD and repeat the
operation.
4. Expand the capacity of the HDD partition of the relevant service.

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm