Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-206
ATS/ APS No Destination Error
The paper specified for printing cannot be detected.
Applicable Fault Codes
• 024-966: ATS/ APS No Destination Error APS/ ATS NG (Other Than No Paper)
Initial Actions
• Inspect the tray to ensure that it is free of obstructions, is loaded with supported paper, and the
Guides are adjusted correctly.
• If the problem persists, perform the following procedure.
Bypass Tray Stop Check
The Bypass Tray stopped running due to an obstruction.
Applicable Fault Codes
• 024-985: Bypass Tray Pause Check
Initial Actions
• Inspect the tray to ensure that it is free of obstructions, is loaded with supported paper, and the
Guides are adjusted correctly.
• If the problem persists, perform the following procedure.
Troubleshooting Procedure
Step Actions and Questions
1. Change the settings.
2. Replace the Tray.
3. If the problem persists, go to Sensor Troubleshooting on page 2-440.
4. If the problem persists, go to Common Job Fail on page 2-407.
Troubleshooting Procedure
Step Actions and Questions
1. Check the paper size/ paper orientation/ paper type settings and press the Eject/Set key.