Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-247
REP 13.4 Transfer Spring Kit/ Latch Frame Kit
PL 13.1.17/ PL 13.1.18
CAUTION: Do not touch the IBT Belt surface.
1. Remove the IBT Unit (REP 9.10 IBT Unit on page 4-177).
Note: When removing the IBT Unit, release the spring from its shelter if it had been put aside, and
then remove the Top Spring from the hole at the side surface to free it completely.
2. Remove the E-ring (PL 13.1) from the Latch Shaft Assembly (PL 13.1.2).
3. Remove the Top Right Latch (PL 13.1.50 from the Right Top Shaft PL 13.1.3).
4. Shift the Latch Shaft Assembly to the left and remove the Spring Pin (PL 13.1.19) that is attached
to the right of the Latch Shaft Assembly.
5. While pulling out the Latch Shaft Assembly further to the left, remove the 2 Top Sleeves (PL
13.1.16) and the Left and Right TRNS Springs (PL 13.1.17/ PL 13.1.18) from the Latch Shaft
Assembly.
6. Remove the Top Left Latch from the Latch Shaft Assembly.
To Next Page
Loading...
