General and Operation Overview
Phaser 7100 Service Manual Xerox Internal Use Only1-18
Introduction
The Phaser 7100 color laser printer has a single-pass color laser-design architecture based on the
electrophotographic recording principle, which offers color and mono print speed at 30/30 ppm, and
resolutions up to 1200 x 1200 dots-per-inch (dpi). The printer supports Adobe PostScript 3 and PCL6,
USB 2.0, and 10/100 Base-TX Ethernet. The Phaser 7100 printer provides a standard 150-Sheet Bypass
Tray and a standard 250-Sheet Tray 1. The Bypass Tray supports specialty media, card stock, and
envelopes. The standard paper input is 400 sheets and the maximum input with optional Trays 2, 3,
and 4 is 2,050 sheets. The Output Tray holds 250 sheets facedown.
The printer options add memory, paper capacity, and functionality. Memory upgrades are available to
increase the standard RAM from 1 GB up to 2 GB maximum. A 40 GB Hard Disk Drive and a 550-Sheet
Feeder (up to 3 total) are available as an option. Auto-duplexing is available and no tools are required
to install the Duplex Unit.
To Next Page
Loading...
