Xerox Phaser 7100 Service Manual

General and Operation Overview
Phaser 7100 Service Manual Xerox Internal Use Only1-80
Operation Mode
The following 4 modes are available in the Phaser 7100 printer: Running Mode, Ready Mode, Low
Power Mode, and Sleep Mode.
Running Mode
Running Mode contains operating states such as data receive/ image creation, or recording (print).
Ready Mode
The printer is ready to print at Ready state. It is possible to enter this mode within the Warm Up Time
after power Off and On or from the Energy Saver Mode.
Low Power Mode
To reduce energy consumption, the printer will enter Low Power Mode when it has not received any
print data within a certain time after it has entered Ready Mode. The waiting time before switching to
this mode is set at 1 minute by default. It can be set in increments of 1 minute in the range between 1
and 60 minutes from the Control Panel. Furthermore, it can also changes when the Energy Saver
button is pressed. The printer can be set to prohibit the transition to Low Power Mode or Sleep Mode.
Furthermore, the printer will enter or exit the Low Power Mode when the Energy Saver button is
pressed.
When the printer receives a Print Job or when the Energy Saver button on the Control Panel is pressed,
Low Power Mode will be canceled.
Sleep Mode
To reduce energy consumption, the printer will enter the Sleep Mode when it has not received any print
data within a certain time after it has entered the Ready Mode or the Low Power Mode. (When an
error, such as Out of Toner, has occurred, the printer will not transition to Sleep Mode unless the
transition condition has been fulfilled). The waiting time before switching to this mode is set as 1
minute by default. It can be set in increments of 1 minute in the range between 1 and 60 minutes from
the Control Panel. Furthermore, it can also transition when the Energy Saver button is pressed. The
printer can be set to prohibit the transition to Low Power Mode or Sleep Mode.
When the printer receives a Print Job or when the Energy Saver button on the Control Panel is pressed,
Sleep Mode will be canceled.

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm