Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-129
REP 6.5 Left Imaging Unit Guide Assembly
PL 6.1.13
CAUTION: Do not expose the Imaging Unit to light for more than 5 minutes. Cover the Imaging
Unit to avoid damage. Do not touch the surface of the Imaging Unit.
1. Remove the Imaging Unit (Y/ M/ C/ K) (REP 6.0 Imaging Unit (Y/ M/ C/ K) on page 4-121).
2. Remove 4 screws (silver, 6 mm) that secure the Left Imaging Unit Guide Assembly to the printer.
3. Pull the front side of the Left Imaging Unit Guide Assembly to the right to release the boss at the
front, and then release the boss at the rear to remove the Left Imaging Unit Guide Assembly.
Replacement Note: Be sure to install the Shaft of the (Y/ M/ C/ K) Developer Housing Assembly (PL
8.1.5/ PL 8.1.6/ PL 8.1.7/ PL 8.1.8) properly before installing the Left Imaging Unit Guide Assembly.
To Next Page
Loading...
