Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-382
124-326 IOT Speed Not Registered
At boot, the status of speed registration procedure for IOT was detected to be 1 or 2.
Applicable Fault Code
• 124-326: IOT Speed Not Registered
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. This failure will start the IOT speed change procedure and the user should follow the dialog that is
displayed on the UI to enter the SW Key for IOT speed change.
To Next Page
Loading...
