Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-103
REP 4.8 Chute Assembly
PL 4.2.17
WARNING: The Fuser may be hot. Turn the printer power Off and allow at least 30 minutes for
the Fuser to cool before removing the Fuser.
1. Remove the Fuser Unit (REP 10.1 Fuser Unit on page 4-183).
2. Remove the Transfer Roller (2nd BTR Unit) (REP 4.10 Transfer Roller (2nd BTR Unit) on
page 4-108).
3. Remove 2 screws (silver, tapped, 8 mm) that secure the Chute Assembly to the Front Frame
Assembly and remove the Chute Assembly.
To Next Page
Loading...
