Xerox Phaser 7100 Service Manual

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-118
Job Ticket Out of Memory
Insufficient memory was detected when the XPIF parser is interpreting the Job Ticket.
Applicable Fault Code
• 016-570: Insufficient XPIF Memory
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Job Ticket Wrong Parameter
The decomposer detected an instruction content in the Job Ticket that cannot be applied within the
device specification.
Applicable Fault Code
• 016-571: Mismatched XPIF Parameters
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. At the Control Panel, increase the memory size for use by the Job Ticket, then reboot the printer and
perform the Job again.
Troubleshooting Procedure
Step Actions and Questions
1. Check the parameters that had been specified in Job Ticket for mismatches, correct the specification
as required, and then send the Job again.

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm