Xerox Phaser 7100 - Max. User Number Exceeded; Sample Print Fail

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-124
Max. User Number Exceeded
Full status was detected at HDD access and the job was aborted.
Applicable Fault Code
• 016-706: Job Canceled due to Detection of Exceeded Maximum No. of Users for Secure and Proof
Prints
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Sample Print Fail
Proof Print Registration failed because it cannot be stored without a HDD.
Applicable Fault Code
• 016-707: Unable to perform Proof Print (Does not satisfy the conditions for Proof Print due to HDD
not installed/ HDD error etc.)
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Delete unnecessary documents/users and print again.
Troubleshooting Procedure
Step Actions and Questions
1. Remove the conditions that disable Sample Set.
2. Check whether the HDD is installed.
If the problem has occurred at installation, check whether the operations for Sample Set are correct.