Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-132
Invalid TIFF Data
Invalid TIFF data error has occurred.
Applicable Fault Code
• 016-731: <Invalid TIFF File> The TIFF data is broken or cut off halfway
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Form Not Registered
The decomposer detected that the form specified is not registered.
Applicable Fault Code
• 016-732: <Form Overlay Error> Data itself is not printed when the form specified is not registered
in emulation.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Resend the data.
Troubleshooting Procedure
Step Actions and Questions
1. Resend the form data.