Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-467
UNIX/ Linux
This section includes:
•Quick Install Steps
• Additional Resources
Your printer supports connection to a variety of UNIX platforms through the Network interface. The
workstations currently supported by CentreWare for UNIX/ Linux to a network-connected printer are:
• Sun Solaris
•IBM AIX
• Hewlett-Packard HP-UX
• Linux (i386) tested on SUSE 10.0, RedHat 9, Fedora Core1
The following procedures enable you to connect your printer using any of the supported versions of
UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the appropriate drivers.
From the Printer
To set up the printer:
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. On the Control Panel, select one of these IP address options:
• Allow the printer to set up a DHCP address
• Enter the IP address manually
3. Print the Configuration page and keep it for reference.
From Your Computer
To install the CentreWare for Unix driver:
1. Go to www.xerox.com/office/7100drivers.
2. Under the Operating System pull-down menu, select the platform your are running (UNIX), and
file type (Drivers).
3. Click Go to Downloads.
4. From the list of provided files, download the PrinterPackageXPXX and the appropriate
CentreWare printer driver for your platform <OS>XPXX 4.xx.x.tar.
a. As root untar the Driver and Printer package, this will create two subdirectories. Cd to
<O/S>InstallPackage and type ./setup to install the driver.
b. CD to the PrinterPackagexpxx and type ./setup to install the printer specific data files.
c. Type xpadmin to open the admin tool for creating print queues. Select the printer from the
list of discovered printers you want to print to. Click on the printer icon at the top left of the
screen to add a print queue.
To Next Page
Loading...
Need help?
General