Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-275
REP 15.14 Feed Roller Clutch
PL 15.2.13
1. Remove the 550 Left Feeder Cover (REP 15.8 550 Left Feeder Cover on page 4-268).
2. Remove the 550 Right Feeder Cover (REP 15.2 550 Right Feeder Cover on page 4-262).
3. Remove the Protect Cover Assembly (REP 15.5 Protect Cover Assembly on page 4-265).
4. Remove the Feeder Sub Assembly (REP 15.12 Feeder Sub Assembly on page 4-272).
Note: P/J220 should have been disconnected during the Feeder Sub Assembly removal procedure.
5. Remove the E-ring that secures the Feed Roller Clutch to the Feed Shaft (PL 15.2.18).
6. While freeing the depressed part of the Feed Roller Clutch from the protrusion of the Top Retard
Holder (PL 15.2.11), remove the Feed Roller Clutch by pulling it out from the Feed Shaft.
To Next Page
Loading...
