Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-211
Remote Download File Checksum Error
The checksum of the Remote Download file that is notified from the EP Center and the checksum of
the file that was actually downloaded are mismatched.
Applicable Fault Code
• 026-725: Remote Download File Checksum Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure.
Can't Detect Paper Size of Specified Tray
Paper Size of specified tray is unknown.
Applicable Fault Code
• 026-730: Paper Size of Specified Tray is Unknown
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure.
Troubleshooting Procedure
Step Actions and Questions
1. The checksum value that is registered in the EP Center and the checksum of the file that is stored in
the SW repository must be checked for matching. Contact the Support Department to request for
instructions.
Troubleshooting Procedure
Step Actions and Questions
1. Check the position of the Guides in the Tray that was specified for the print Job and then try again.
2. Check the position of the Paper Size Switch.