Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-363
116-718 Selected PLW Form Not Registered
The specified form is not registered.
Applicable Fault Code
• 116-718: <PLW form synthesis error> The specified form is not registered.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
116-720 PCL Memory Low, Page Simplified
Memory error has occurred.
Applicable Fault Code
• 116-720: PCL Memory Low, Page Simplified
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Use a registered form or register the required form.
Troubleshooting Procedure
Step Actions and Questions
1. Deactivate the unnecessary ports.
Adjust various buffer memory sizes. Increase the memory.