Xerox Phaser 7100 Service Manual

Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-119
REP 5.4 Turn Clutch Assembly
PL 5.1.9
1. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
2. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
3. Remove the Left Side Cover (REP 1.10 Left Side Cover on page 4-25).
4. Remove the Paper Handling Drive Assembly (REP 11.7 Paper Handling Drive Assembly on
page 4-197).
Note: P/J453 has been disconnected in the Paper Handling Drive Assembly removal procedure.
5. Remove 2 screws (silver, tapped, 10 mm) that secure the CTD Harness Cover (PL 11.1.29) to the
printer and remove the CTD Harness Cover.
6. Remove the E-ring that secures the Bypass Tray Idle Gear (PL 5.1.10).
7. Pull out and remove the Bypass Tray Idle Gear from the Bypass Tray Turn Roller.
8. Release the harness that is connected to the Turn Clutch Assembly from the Harness Guide.
9. While freeing the depressed part of the Turn Clutch Assembly from the protrusion of the printer,
remove the Turn Clutch Assembly by pulling it out from the Bypass Tray Turn Roller.
Figure 1
Replacement Notes:
– Be sure to place the Gear with the thick side facing the inner side.
– Align the Clutch with the notch (see Figure 1 on page 4-119).
s7100-124
P/J453
Harness Guide

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm