General and Operation Overview
Phaser 7100 Service Manual Xerox Internal Use Only1-84
Job Spool
During LPD/ SMB, HDD Spool is possible. When there is no Hard Disk Drive, spooling is possible as long
as enough memory can be freed up in the RAM to perform the spooling.
Receive Filter (IP Packet Filtering Function)
This provides a function to restrict incoming packets at the IP Protocol (IPv4/ IPv6) level.
1. IP Address Filter
This provides the IPv4 Address related filter and the IPv6 Address related filter. This IPv4 Address
related filter is applied to IPv4 packets while the IPv6 Address related filter is applied to IPv6
packets.
– IPv4 Address related filter
– The system data consists of a base IPv4 Filtering and a Mask value, and up to 25 (SC16163)
sets (10 sets from the UI) of these can be registered.
– IPv6 Address related filter
– The system data consists of a base IPv6 Filtering and a Mask value, and up to 25 (SC16163)
sets (10 sets from the UI) of these can be registered.
2. Protocol Type Filter
– This restricts the Protocol Type that can be recognized at the IP layer.
3. TCP and UDP Port Filter
– This restricts the sender port and the recipient port numbers that are attached to the received
packets by their port numbers.
Secure Print
The printout will not be output until the User Password (up to 12 single byte alphanumeric character)
that is specified at the Print Driver is input at the printer Control Panel. You can also specify whether to
delete the data in the printer after the printout is output. The data will remain stored in the printer
until it is deleted, and it is retained even after the power is turned Off and On.
Sample Set (Proof Print)
At the start, only one set will be printed out. After that, you can instruct whether to print out the
remaining sets or not (deletes the remaining data) at the printer Control Panel. The data will remain
stored in the printer until it is deleted, and it is retained even after the power is turned Off and On.
Delayed Print
Delayed Print allows user to set a time to start the print job. A print job can be delayed up to 24 hours
from the original job submission time. The Delayed Print default time is midnight.
To Next Page
Loading...
Need help?
General